PitLab Body Support & Anti-Tuck Twister/Twister Special

Only works with Twister and Twister special bodies

Anyone who has run a body shell without proper support knows the frustration. One hit and the rear tucks under, the shell shifts sideways, and suddenly your run is over before it should be. The PitLab Body Support and Anti Tuck was built specifically to solve that problem.

This is a purpose built solution that holds your body shell exactly where you put it. It braces the shell from underneath and prevents the front edge from folding or tucking inward during nose dives, hard braking, and rough landings. Once it is installed you will notice right away how much more solid the whole setup feels.

What you get with this upgrade:

Reliable body shell positioning that stays consistent through every run. Anti tuck protection that stops the front of your shell from folding under during aggressive driving. A low profile design that fits cleanly without adding unnecessary weight or bulk. Broad compatibility across popular 1/10 scale and similar RC platforms. Straightforward installation that takes minutes and lasts the life of your build.

The difference between a clean run and a frustrating one is often a handful of small details done right. This is one of them. Drivers who run it once rarely go back to skipping it. It is the kind of part that earns its spot on the build permanently.

Whether you are chasing lap times at the track or just want your rig dialed in from nose to tail, the PitLab Body Support and Anti Tuck gives you one less thing to worry about out on the course.