X1'24 Rear Bulkhead Brace 2.5MM 373054

If you've ever pushed your X1'24 hard through a technical section and felt that rear end flex under load, you already know why this part exists. The Rear Bulkhead Brace at 2.5MM thickness is one of those upgrades that quietly does a lot of heavy lifting without asking for any attention.

Machined to fit the X1'24 platform, this brace locks the rear bulkhead in place and keeps your geometry consistent lap after lap. When the rear end is properly supported, your car responds more predictably, your diff stays in alignment, and you stop chasing setup changes that were never really setup issues to begin with.

The 2.5MM spec hits a sweet spot between rigidity and weight. It's stiff enough to eliminate unwanted flex but not so heavy that you're compromising your rear weight distribution. Racers who have made the switch often notice the improvement immediately, especially on high bite surfaces where rear stability makes the biggest difference.

Whether you're building a fresh X1'24 or tightening up a car that's been through a season of racing, this brace is a straightforward addition that pays off every time you put the car on the track.

Fits: Associated RC X1'24 Material: Aluminum Thickness: 2.5MM